Scouse moderator
Joined: 15 Sep 2003 Posts: 5266 Location: Wollondilly, NSW
|
Posted: Wed Jan 31, 2007 9:35 pm Post subject: |
|
|
This is just to connect the ignition warning light, right ?
Not the main charging lead ?
If for the warning light, just connect the ign side of the light to the ignition side of the switch.
Use a test light if you are unsure which wire to use. You'll have a permanent power wire to the switch, one that's live on accessories, one that's live with ignition & one that's live in the start position.
Don't forget that with the ignition on, you'll have 2 power wires (acc & ign) on at once - make sure you don't hook it up to the accessory wire.
Do you have it connected OK at the alternator end ?
|
|